User manual

86-86000-00 B02 - Page 38
2. Setup and Installation
Proceed as follows:
1. For normal AC input, make connections to L1, L2, and
terminals only. No connections are required for
Bypass AC input. Make connections to
, L5, L6 terminals for output.
CAUTION
Always connect the earth ground wire first.
Jumper must be between L1 and L3. System is factory configured for 208 VAC
output.
2. Attach I/O Box to the Power Module with three screws.
Figure 2-12: Normal AC Input and Output Cables Installation.
1
2
OFF
O
OFF
O
Output to Load
or
Transformer Module
(if applicable)
AC INPUT
UPSTREAM
CIRCUIT
BREAKER
(NOT SUPPLIED)
To Load or
Transformer Module
(if applicable)
Normal AC
Simplified Connection Diagram
Normal AC Input
Output
L6 L5 L2 L1 L1 L4 L3
Jumper
Output
200/208/220/230/240 Vac
Normal AC source
200/208/220/230/240 Vac
Bypass AC source
200/208/220/230/240 Vac
To Load
208 VAC
From Utility
208 VAC
Power Module I/O Box
Bypass AC