User manual

86-86000-00 B02 - Page 32
2. Setup and Installation
NOTE
This step is unique to the Power Module. It involves the installation of the I/O Box
Bracket System.
The I/O Box bracket system keeps the I/O Box stationary while hot swapping the Power Module. It will then be
easier to slide the replacement module into the connectors of the I/O Box.
1&2. Secure small brackets to larger bracket from the underside
27
.
3. Secure small attached brackets to the I/O Box with four screws.
4. Secure large bracket
27
to rails at the rear of modul e with four nuts.
Figure 2-7: Input/Output Box Bracket System.
OFF
1
2
4
4
3
Install input/output cables
per section 2.7 prior to this step.