User manual

86-86000-00 B02 - Page 31
2. Setup and Installation
2.4.3 Power, Battery, Transformer, and CLA Charger Module Rack Mounting
The following steps apply to all modules. For simplicity, only Power Module is shown.
Proceed as follows:
1. Attach both front mounting ear brackets
24
to module with supplied screws. (For this step, it is possible to
adjust the position of both front mounting brackets.)
2. Attach rear support brackets
25
to module. These brackets prevent the module from sliding out of the rack.
3. Attach rails
26
together, secure with wing nuts, and finger tighten. (both sides).
4. Attach both rails to rear and front of rack with supplied flathead screws (as shown).
5. Use caution when sliding unit into rack. Temporarily secure unit to rack with thumb screws on front
mounting brackets.
6. Secure rear support brackets to rails.
Figure 2-6: Rack mounting of the Power Module onto the rails.
3
4
4
4
4
2
2
1
4
4
5
1
6
6
6
6