User's Manual

1. Highlight SET-UP on the
Menu.
2. Using the and keys,
highlight “TIME” and
press “OK”.
3. Use the keypad to adjust
the time and date.
EXAMPLE:
To set the time to
12:34 PM, press 1, 2,
3, 4, and press “OK”.
www.bratz.com
TM & © MGA Entertainment, Inc.
BRATZ™, BRATZ PETZ™, LIL’ BRATZ™,
BRATZ BABYZ™, BRATZ KIDZ™ and all
related logos, names, characters,
distinctive likenesses and slogans,
as well as the packaging and images
appearing thereon, are the
exclusive property of MGA.
16300 Roscoe Blvd.
Van Nuys, CA 91406 USA
[phone]
Printed in China.
0507-0 E
The preferred method of contact for
Customer Service is through our e-mail
contact form at www.mgae.com
Please keep this manual as it contains important information.
13 14 15 16
9 10 11 12
FCC WARNING STATEMENT
FCC Compliance
NOTE: This equipment has been tested and found to comply with the limits for
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Modifications not authorized by the manufacturer may void users
authority to operate this device.
IC RSS210 WARNING STATEMENT
This device complies with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause
undesired operation of the device.
Operation temperature
The product can only be operated from 0 degrees centigrade to 35 degrees
centigrade.
Warning: Changes or modifications to this equipment not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
Warning: Any adjustment to this equipment is recommended to be performed by
or under the immediate supervision and responsibility of a person certified as
technically qualified to perform transmitter maintenance and repair duties in the
private land mobile services and fixed services by an organization or committee
representative of users of those services.
Warning: Replacement of any transmitter component (crystal, semiconductor,
etc.) for this equipment could result in violation of FCC rules.
SAFETY INFORMATION
Your wireless hand-held portable transceiver contains a low power transmitter.
When the Push-to-Talk (PTT) button is pushed it sends out radio frequency (RF)
signals. The device is authorized to operate at a duty factor not to exceed 50%.
In August 1996, the Federal Communications Commissions (FCC) adopted RF
exposure guidelines with safety levels for hand-held wireless devices.
CAUTION: To maintain compliance with the FCC's RF exposure guidelines hold
the transmitter and antenna at least 1 inch (2.5 centimeters) from your face and
speak in a normal voice, with the antenna pointed up and away from the face.
Use only the supplied antenna. Unauthorized antennas, modifications, or
attachments could damage the transmitter and may violate FCC regulations.
This Class B digital apparatus complies with Canadian ICES-003.
SAFE BATTERY USAGE
• Use alkaline batteries for best performance and longer life
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix different types of batteries or old and new batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible
leakage and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the units.
• Do not dispose of batteries in fire as they may leak or explode.
DISPOSAL OF BATTERIES: Do not treat old batteries as household waste.
Take them to a designated recycling facility.
NOTE: The voltage of a fully-charged, rechargeable battery is often lower than
that of a fresh alkaline battery. Therefore, it is recommended that alkaline
batteries be used instead of rechargeable batteries for best performance and for
longest play time.
SETTINGS
• In Mode “B”, press the and keys to highlight the “SETTINGS’ menu.
(Fig. 20)
• Press “OK”.
CHECKING YOUR ID NUMBER
• To check your ID number, go to “B” Mode, press the CANCEL key until no
icons are highlighted, then press the “ID” key on the side of your Mobile
Handset.
TO CHANGE ID NUMBER OR ERASE ALL DATA
• To change your ID number, go to “B” Mode, press the CANCEL key until no
icons are highlighted, then press **00000000## then press “OK".
To adjust any of the 2 items below, first go to “B” Mode, press the CANCEL key
until no icons are highlighted, then press **00000000## and “OK” then press 0
or 9.
Fig. 19
• Press “OK” to move to the next note.
NOTE: You can save a maximum of 8 notes.
APPLICATIONS
• In Mode “B”, press the and keys to highlight the “EXTRAS” menu.
(Fig. 19)
• Press “OK”.
• Use the keypad to Input any notes you wish and press .
• A new menu (Fig. 18) will appear.
• To save your notes, use the or keys to highlight “SAVE” and press “OK”.
• To erase your notes, use the or keys to highlight “DELETE” and press
“OK”.
Fig. 16 Fig. 17
NOTE 1 A
Fig. 18
SAVE
DELETE
NOTES
• In Mode “B,” use the and keys to highlight“ the “NOTEPAD” icon on the
menu (Fig. 16).
• Press “OK” and a new menu (Fig. 17) will appear.
Go to movies with
Jimmy
TASK A
TASK TIME
12:34 PM
To do list
Function Step
1. Use the or keys to highlight
“TO DO LIST” then press “OK”.
2. The current month and year will
be shown.
3. Use the or keys to scroll
through the “TO DO LIST”.
4. Press the key to highlight the
date you want select
e.g. 2007 Jan 2nd
5. Press the key to select
2007 Jan 2nd
6. Select “EDIT” to input a To-Do List
message
e.g. “Go to movies with Jimmy”
7. Use the keypad to input your
message.
8. After you have input your
message, press “OK”. “TASK
TIME” will appear.
9. To set the time to 12:34 PM,
press 1 2 3 4 and to
select “PM”.
10. Once you have set the “time” on
the To-Do List message, press
“OK” to save it.
11. To Delete a saved message,
highlight the date of the message
then press the right arrow.
12. Select “DELETE” to delete the
message, then press “OK”.
EDIT
DELETE
1
01-2007 <>
2
3
1
01-2007
2
3
Fig. 20 Fig. 21
To select a Ring Tone.
To adjust the Ring
Volume.
Function Step
1. Highlight SET-UP on the Menu.
2. Using the and keys, highlight “RING TONE” and
press “OK”.
3. Using the and keys, highlight the ring tone you
desire and press “OK”.
NOTE: Five pre-set ring tones are available and a sample of
each will play when highlighted.
1. Highlight SET-UP on the Menu.
2. Using the and keys, highlight “RING VOL” and
press “OK”.
NOTE: Eight pre-set volume settings are available and a
sample of each will play when highlighted.
To adjust the Time
Setting.
NOTE: After you change your batteries, the Mobile Handset
will automatically be reset. The initial setting of time and
date will revert to 12:00 AM, 2007 Jan 1st
12:00 AM
2007.01.02
12:34 PM
2007.01.02
In Text Mode with no icons highlighted on the Menu, press
**00000000## and “OK” to confirm.
1. Press “0”
2. Press Cancel
To erase the data in your
mailbox, to-do list, and
phone book
In Text Mode with no icons highlighted on the Menu, press
**00000000## and “OK” to confirm.
1. Press 9, then “OK” to confirm.
2. Enter a new 8 digit ID number and press “OK” to
confirm.
3. Press Cancel
To change the ID
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with
other household waste. Please use designated collection points or recycling
facilities when disposing of the item