Owner Manual

Catalyst Owner’s Manual | © MF Fire 2017 Page | 36
Monthly Maintenance
Creosote
When wood is burned slowly, it produces tar and other organic vapors,
which combine with expelled moisture to form creosote. The creosote
vapors condense in the relatively cool chimney flue of a slow-burning
fire. As a result, creosote residue accumulates on the flue lining. When
ignited, this creosote makes an extremely hot fire.
The chimney and chimney connector should be inspected at least once
every two months during the heating season to determine if a creosote
buildup has occurred. If creosote has accumulated, it should be
removed to reduce the risk of a chimney fire.
The use of unseasoned (wet, green) wood will increase the formation
of creosote.
If you are not confident in performing a creosote inspection, contact a
local chimney sweep to perform an inspection. Excess creosote
buildup may cause a chimney fire that may result in property damage,
injury, or death.
Soapstone (Optional)
The optional soapstone top on the Catalyst can be removed of light
scratches by lightly sanding the surface using a fine abrasive
sandpaper or Grade 1 (medium) steel wool. Any soapstone dust
created by sanding should be removed with a vacuum.
Room Blower (Optional)
The optional room blower can be cleaned by using a vacuum to remove
excessive dust.
Gasket
There is gasket located on the front door, and on the front door glass.
The gasket in these areas should be visually inspected for any signs
of deterioration or smoke leakage into the room. If the gasket is
deteriorating, contact MF Fire for replacement gasket.