User guide

CD-3706/P Operator’s
Guide
Document Revision: 030501.1
Scribe EC Standalone Series
Operator’s Guide
Document Revision: 011804
Page 58
• Enter the 4 sets of numbers of the subnet. Pressing “START/YES”
after each set. You will then see:
• Press the “START/YES” key and then Restart the system by turning
it Off and back On again.
Configuring the Client
• Place the firmware CD into the CD-ROM drive of your PC
• Double click on “Embedded” folder
• Double click on SaClient.exe
• Press “Connect” in the lower right hand corner