Installation guide

Page 15
Director EC Office Publisher
with OptiEC PRO Printer
Installation Guide
Document Revision: 2005/05/20
Aligning the OptiEC PRO Printer
(fig. 3)
(fig. 4)
(fig. 5)
Alert:
Before starting the Alignment Utility,
position the back end of the inkjet printer
in line with the dotted line on the top of
the drive bay.
1. From the Start Menu Open the SCRIBE EC
Alignment Utility. It will be located in the
folder designated when you installed the
alignment utility. Choose the appropriate COM
Port Number, which the Scribe EC Loader is
connected on. Then choose the OptiEC and
click the Start Test button (fig. 1).
2. Follow the onscreen instructions then click the
Yes button (fig. 2). The picker arm will then
hover the disc over the open printer tray.
Observe disc’s position and make the
appropriate adjustments to the printer (fig. 3).
3. Click the Yes button when you are satisfied
with your adjustment (fig. 4).
4. The picker arm will then place the disc onto
the printer tray. Follow the on screen
instructions and click the OK button (fig. 5).
5. Once you are satisfied with the printer’s
alignment, tighten the thumbscrews located on
both side of the printer (fig. 6).
(fig. 1)
(fig. 6)
(fig. 2)