Owner`s manual

ManualsBrandsMeyer ManualsIndustrialV-MAX 3954 Operators

PB-SV - 25 -

LUBRICATION

WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC

PRESSURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS MACHINE. FAILURE

TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

DAILY LUBRICATION (every 8-12 loads)

Grease (2) rear spinner lower bearings. These

bearings are grease line fitted to the LR frame

channel of the spreader.

Oil (5) roller chain drives regularly at the front

of spreader with light weight machine oil. The roller

chains are accessible by opening the front steel

shielding cover.

Grease PTO Drive line (9) places with Lithium

grease every 8 hours. (See PTO LUBRICATION

section for further detail.)

Grease (4) bearings supporting the two large

jack shaft reduction sprocket weldments on the front

drive. The zerks are accessible by opening the front

steel shielding cover and through the front bearing

plate.

Grease (2) auger shaft bushings. These

bearings are grease line fitted to the RF shield of the

spreader. Grease Daily, Minimum of 10 pumps. Over

greasing is not possible.

WEEKLY LUBRICATION (every 25-30 loads)

Grease (2) PTO input shaft bearings. These

bearings are grease line fitted to the RF shield of the

spreader.

Grease bearings on the RH side line shaft. The

front bearing is zerk accessible through the RF steel

shielding. The remaining rear bearings are located

along the RH side of the spreader tank, zerks

accessible through the steel shielding.

Grease (4) tandem wing pivots. Effectively

grease by jacking up the spreader to relieve pressure

points on the pivot shaft and tandem wing collar. Over

greasing is not possible.

Grease (2) flow control rear gate and lifting

arm pivot points. Grease gate pivot at center of flow

control rear gate. Grease lifting arm pivot support at

LR of spreader. Over greasing is not possible. Apply

grease to slot in gate lift arm.

Grease (2) flow control rear gate slide guides.

With the flow control rear gate opened, grease the

slide guides from the zerks on the side. Allow grease

to lubricate flow control rear gate ends and slide guide

surfaces. In freezing weather dump used motor oil

down each slide guide once a week or more often if

needed. Over greasing is not possible.

Grease (1) integral overrunning clutch at rear

of the PTO drive line. The zerk is on the yoke of the

clutch. Use Shell Super Duty or an equivalent lithium

grease.

Check regularly for any observable lube

leakage of the (3) gearboxes at the rear of the

spreader. See L12 under MONTHLY LUBRICATION,

page 26.

L10

L11

L12