Owner`s manual

PB-SV - 22 -
ADJUSTMENTS
WARNING: DISCONNECT PTO DRIVE SHAFT AND HYDRAULIC HOSES (RELIEVE HYDRAULIC
PRESSURE) BEFORE CLEANING, ADJUSTING, LUBRICATING OR SERVICING THIS SPREADER. FAILURE
TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
SPINNER MATERIAL GUIDES
Regularly inspect and adjust two spinner material
guides located at both the LR and RR of the spreader.
Create a 1/8 - 3/8” clearance between material guides
and spinner teeth, figure 10. Maintain the
recommended clearances for maximum spreading
pattern. Adjust to prevent excessive manure build-up
on material guide inner surfaces. Adjust to prevent
manure chunks or foreign object lodging between
material guides and spinner teeth.
NOTE: Excessive lodging can cause premature
spinner tooth wear, “bent-over” or even
breakage.
Adjustments for the 1/8-3/8” clearance of each
material guide to spinner tooth is made by tightening
or loosening the 1” nut on the material guide spring
linkage shaft assembly. Tighten nut to increase
clearance and loosen nut to decrease clearance
between the material guides. Once recommended
clearance is obtained turn spinners over by hand in
the direction by which the spreader would turn to
check clearance. Do not turn in the opposite direction
as front chain tightener damage could occur.
Effective w/08 serial numbers
If foreign objects enter the spinner area, the rear pivot
bolt on the shear arm is designed to shear. The 3/8-
16x3” grade 5 replacement machine bolts are stored
under the rear shield. For replacement install with 3/8”
flat washer on top and on bottom of block and tighten
nylon locknut firmly.
FIGURE 10. MATERIAL GUIDE CLEARANCE
1/8 - 3/8”