Owner`s manual

Model 8720 / 8865 -14-
5.5.2. PTO, ATTACHMENT OF
The cutout clutch end of the PTO driveline must always be attached to the implement. The PTO driveline is
equipped with a 1 3/8-6 spline on the implement half for attaching to the spreader. Remove the M17-
hexagon bolt from the splined hub and slide the PTO onto the implement splined input shaft. Install the
hexagon bolt through the hub being sure the bolt is falling into the groove on the splined shaft. Torque tight
using a metric size M17 6-point socket and torque down to 75 ft. lbs. A M17 6-POINT METRIC SOCKET
MUST BE USED AS ROUNDING OF HEXAGON BOLT AND INACCURACY OF TORQUE SETTINGS
COULD OCCUR.
If removal of the M-17 hexagon bolt is necessary, use the same M-17 6-point socket and loosen bolt ½ turn.
Insert a ¼” drift punch in the hole on the opposite side of the hexagon bolt and tap to loosen the seated
portion of the bolt from the splined hub. Loosen in ½ turn increments and tapping to loosen. After bolt seat
has been released, remove the bolt. If bolt is not unseated, damage to the hexagon bolt will occur.
Attach the shield safety chain to a suitable area on the spreader, preferably to the implement PTO steel
shield.
5.6. OPERATIONAL CHECKS
DANGER: MAKE CERTAIN ALL PERSONNEL ARE CLEAR OF THE SPREADER AND THE
ROTATING SPINNERS BEFORE APPLYING POWER. FAILURE TO HEED MAY RESULT IN SERIOUS
PERSONAL INJURY OR DEATH.
See Lubrication and Adjustment sections for further detail.
Before loading spreader, slowly engage the tractor PTO and operate machine at idle speed for several minutes
to ensure the spreader is lubricated and operating properly.
5.7. TRANSPORTING
5.7.1. SPEED
WARNING: DO NOT TOW AT SPEEDS GREATER THAN 20 MPH. FAILURE TO HEED MAY
RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
Operating speed is dictated by the terrain over which you are traveling. Always use caution. Avoid traveling
on slopes or hills that are unsafe.
5.7.2. PUBLIC ROADWAY TRAVEL
WARNING: OBSERVE ALL APPLICABLE TRAFFIC LAWS WHEN TRANSPORTING ON PUBLIC
ROADWAYS. CHECK LOCAL LAWS FOR ALL HIGHWAY LIGHTING AND MARKING REQUIREMENTS.
WARNING: INSTALL A SMV EMBLEM ON THE REAR OF THE SPREADER FOR
TRANSPORTING ON ROADWAYS AND KEEP THIS EMBLEM CLEAN AND BRIGHT. FAILURE TO
HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.
If you will be traveling on public roadways and it is legal to do so, you must know all rules governing such
operation. This will include lighting, brake requirements, and safety chains, in addition to all local, state, and
federal traffic rules. Lighting and reflective decals need to be clean, visible, and operational.
Check that the rear discharge gate is completely closed. It is unlawful to allow slurry to splash or leak onto
public roadways.
Check for traffic constantly. Be sure that no one is attempting to pass and that all traffic is sufficiently clear
before making any turns.