Instructions / Assembly

6
18. Hook the free end of the ow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See gure 9.
FIGURE 9
FIGURE 10
19. Assemble both the ow control mounting bracket and
the short handle tube to the long handle tube. Use
two 1/4" x 1-3/4" hex bolts, four 1/4" washers and two
1/4" nylock nuts as shown in gure 11. Do not tighten
at this time.
20. Place a handle grip on each handle. See gure 10.
1/4" x 1-3/4"
HEX BOLT
1/4"
NYLOCK
NUT
HANDLE
TUBE
(SHORT)
HANDLE
TUBE
(LONG)
HANDLE GRIP
FLOW CONTROL
MOUNTING BRACKET
1/4"
WASHERS
HOPPER
SLIDE
GATE
BRACKET
FLOW
CONTROL
ROD
FIGURE 11
21. Place the adjustable stop into the "ON" end of the slot
in the top of the ow control mounting bracket. Secure
with the 1/4" x 3/4" carriage bolt, a nylon washer, a
1/4" washer and the nylon wing nut. See gure 11.
1/4" WASHER
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
PLASTIC
KNOB
ADJUSTABLE
STOP
22. Attach an angle stop bracket and a swivel bracket to
the rear hole in the R.H. shield bracket using a 1/4" x
1" hex bolt, two 1/4" washers, a nylon washer and a
1/4" Nylock nut. Place the angle stop bracket on the
inside and the swivel bracket on the outside. Tighten
the locknut so that the swivel bracket can pivot freely.
See gure 12. Repeat step on L.H. shield bracket.
23. Attach a swivel bracket to the front hole in the R.H.
shield bracket using a 1/4" x 1" hex bolt, two 1/4"
washers, a nylon washer and a 1/4" Nylock nut.
Tighten the nut so that the swivel bracket can pivot
freely. See gure 12. Repeat step on L.H. shield
bracket.
SWIVEL
BRACKET
ANGLE STOP
BRACKET
1/4" x 1"
HEX BOLT
1/4"
WASHER
1/4" NYLOCK
NUT
NYLON
WASHER
SHIELD
BRACKET
NYLON
WASHER
FIGURE 12