Instructions / Assembly

5
FIGURE 6
12. Assemble the leg stand tube to the bottom set of
holes in the handle tube (long) using two 1/4" x 1-1/2"
hex bolts and 1/4" nylock nuts. See gure 5.
13. Place a vinyl cap over the end of the leg stand tube.
FIGURE 5
14. Assemble the ow control link (end with small hole)
to the ow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock nut as shown in gure
6. Tighten carefully. The ow control link should not
be loose but should pivot with no more than slight
resistance.
FLOW CONTROL
LINK
FLOW
CONTROL
ARM
1/4"
NYLOCK
NUT
1/4" x 1"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER
FIGURE 7
FIGURE 8
15. Assemble the ow control arm to the ow control
mounting bracket using a 1/4" x 1" hex bolt, two nylon
washers and a 1/4" nylock nut as shown in gure 7.
Tighten carefully. The ow control arm should be snug,
but should pivot with no more than a slight resistance.
16. Assemble the vinyl grip. See gure 7.
17. Place the small washer onto the end of the ow
control rod. Insert the end of the ow control rod
through the slot in the ow control mounting bracket
and through the hole in the ow control link. Secure
with a 3/32" x 3/4" cotter pin. See gure 8.
FLOW
CONTROL
ROD
FLOW
CONTROL
LINK
3/32"
COTTER
PIN
SMALL
WASHER
SLOT
1/4" x 1"
HEX BOLT
1/4"
NYLOCK
NUT
FLOW CONTROL
MOUNTING
BRACKET
FLOW
CONTROL
ARM
(2) NYLON
WASHERS
VINYL GRIP
1/4" x 1-1/2"
HEX BOLTS
1/4"
NYLOCK
NUT
VINYL
CAP
LEG STAND TUBE