Instructions / Assembly

4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
(1) Hammer
(2) 7/16" Open or Boxed End Wrenches
1. Remove the spreader, the loose parts and the
hardware package from the carton. Lay out parts and
hardware and identify using the illustrations on pages
2 and 3.
2. With the spreader resting upside down on the top of
the hopper, assemble a spacer and then a 5/8" at
washer onto each end of the axle. See gure 1.
FIGURE 2
FIGURE 1
FIGURE 3
5. Place a wheel onto the end of the axle that has a cross
hole. The long end of the hub goes to the inside.
6. Assemble a 5/32" x 2" cotter pin through the hole in
the wheel hub and the axle. See gure 3.
7. Place a 5/8" at washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See gure 3.
FIGURE 4
8. Fasten the long handle tube onto the crossover tube
using using a 1/4" x 1-1/2" hex bolt, 1/4" washer, and
1/4" nylock nut. Do not tighten at this time.
9. Assemble two handle braces to the inside of the
hopper frame, one on each side, using two 1/4" x
1-1/2" hex bolts and two 1/4" nylock nuts. Do not
tighten at this time.
10. Assemble the other end of the two handle braces to
the long handle tube using a 1/4" x 1-1/2" hex bolt
and 1/4" nylock nut. Do not tighten at this time.
11. Tighten all nuts and bolts in same sequence as
assembled in steps 8 through 11. See gure 4.
3. Place a wheel onto the end of the axle that has
no cross hole. The long end of the hub goes to the
inside. See gure 2.
4. Place a 5/8" at washer onto the axle and then lightly
tap a hub cap onto the axle until it is snug against the
washer and wheel hub. See gure 2.
SPACER
5/8" FLAT
WASHER
AXLE
5/8" FLAT
WASHER
HUB CAP
WHEEL
NO CROSS
HOLE
HUB CAP
5/32" x 2" COTTER PIN
CROSS
HOLE
5/8" FLAT
WASHER
HEX BOLT
1/4" x 1-1/2"
HEX BOLT
1/4" x 1-1/2"
1/4"
NYLOCK
NUT
1/4" NYLOCK NUT
1/4" WASHER