HOTSHOT COMMERCIAL DROP SPREADER MODEL #38191 38191 DRO P E S PR ADE R OWNER’S MANUAL
ASSEMBLY INSTRUCTIONS Handle Brace Leg 3/16 X 2” Cotter Pin Leg Bracket Nut Lock Washer 1/4-20 X 1/2” Hex Bolt Drive Wheel 1. Remove spreader and components from carton. Place 2. Slide Wheels onto each end of Axle with Hopper on it’s front panel, insert two (2) 1/4-20 X 1/2” Hex Head Bolts through the Leg Bracket (note hole location), flattened end of Handle Brace, and holes in Hopper as shown. Install Lockwashers and Nuts.
OPERATION 1. Before filling Hopper, make sure spreader Handle Lever is in the “OFF” position. Always fill spreader on walk or drive, not on the lawn. 2. Loosen Rate Control Knobs and move the Tie Bar to the desired setting. If setting is not known, try different settings until desired results are achieved. Retighten knobs after setting is made. 3. Always push spreader, do not pull. Start spreader in motion and as it passes over the area to be treated, push Handle Lever to the “ON” position.
Parts List for Model #38191 19 24 15 24 20 18 21 14 17 13 16 25 26 1 22 27 11 2 3RH 12 4 28 6 7 9 5 10 PART OF OUR SERVICE IS PROVIDING REPLACEMENT PARTS. Parts may be obtained through your local distributor. Be sure to give: 1. SPREADER MODEL NUMBER 2. SPREADER NAME 3. PART NUMBER 4. NAME OF PART AS SHOWN ITEM 1 2 3 LH. 3 RH.
