Instructions / Assembly

4. Feed control knob/wire through the
T-handle until spring touches the
round hole. CAUTION: Do Not
Compress Spring At This Time. Feed
wire through the square handle tube.
Be sure wire passes above the bolts in
the handle brace. Secure T-handle to
the tube with 1/4-20 x 2 1/4” hex bolts,
washers, and hex nuts as shown.
Remove caution label and push the
thumb release toward the center and
push down knob and shutoff spring
until knob latches.
CAUTION: Once knob is latched,
do not move thumb release until you have
completed in step #5.
Control Knob &
Wire Assembly
Spring
Thumb
Release
1/4-20 x 2 1/4”
Bolt & Washer
1/4-20 Hex
Nut & Washer
Remove Caution
Label
5 . Slide wire retaining clip onto wire as shown.
Insert wire through hole shutoff plate. Slide
wire retaining clip over shutoff plate and wire
until the clip locks into place.
Wire Clip
Shutoff Plate
Wire
6 . Install handle grips onto the handle
as shown. Soapy water will ease
installation. (Do not use petroleum
based products). Insert screen into
hopper by sliding it under the screen
clips. Install defector shield removed in
step #1.
Screen
Screen Clips
Handle Grips
3
Deflector Shield