Instructions / Assembly

ManualsBrandsMeyer ManualsKitchen216 lb. 4 in. Strap-on Tailgate Spreader

Meyer Products reserves the right, under its continuing product improvement program, to change construction or design details,

specifications and prices without notice or without incurring any obligation.

PARTS & INSTALLATION INSTRUCTIONS

MEYER MINI SPREADER

Form No.1-809 R4

May 2010

18513 Euclid Ave. • Cleveland, Ohio 44112-1084

Phone 486-1313 (Area Code 216)

email•warranty@meyerproducts.com

Meyer Products assumes no responsibility for installations not made in accordance with these instructions.

INDEX

INSTALLATION INSTRUCTIONS .......................................... PAGE 1

A. INSTALLATION OF HOPPER ...................................... PAGE 1-2

B. ELECTRICAL INSTALLATION .................................... PAGE 3-4

C. OPERATION OF MATE ............................................... PAGE 1

D. MAINTENANCE INSTRUCTIONS ............................... PAGE 1

WARRANTY STATEMENT ..................................................... PAGE 4

MATE

Summary of content (6 pages)

PAGE 1
Form No.1-809 R4 May 2010 PARTS & INSTALLATION INSTRUCTIONS MEYER MINI SPREADER MATE INDEX INSTALLATION INSTRUCTIONS .......................................... A. INSTALLATION OF HOPPER ...................................... B. ELECTRICAL INSTALLATION .................................... C. OPERATION OF MATE ............................................... D. MAINTENANCE INSTRUCTIONS ............................... WARRANTY STATEMENT .....................................................
PAGE 2
INSTALLATION INSTRUCTIONS Caution: The ratchet should be tightened before each use. The strap should be inspected for tears before each use. If strap is torn or damaged it must be replaced! CAUTION: Always disconnect battery before beginning installation. Note: To remove the spreader, pull the tab (B) sideways, located on front mid section of the ratchet. While holding the tab (B) in the unlocked position pull the lever handle fully open.
PAGE 3
PARTS LIST Item Part No. Qty.
PAGE 4
B. 6.) Move to engine compartment. Connect power leads to battery: RED WIRE (+) positive, BLACK WIRE (-) negative. Coat the connections with dielectric grease to prevent corrosion and build up. Check harness marked ‘battery’ for voltage by temporarily removing the red tape affixed to it. ELECTRICAL INSTALLATION. Refer to Figure 2. If routing wires underbody to the rear of the chassis, it is recommended to route the wire to the inside of vehicle frame rail.
PAGE 5
ELECTRICAL INSTALLATION SPEED CONTROLLER 22800 with VIBRATOR FIGURE 2 38056 36” Vibrator Wire Extension To Speed Control Red 39 Mounting Bracket Red Blue White Ground Red White Red Pigtail 40 Red To Battery To Spreader Motor Black ONE YEAR WARRANTY ONE YEAR WARRANTY Meyer Products and Diamond Equipment promises to the consumer to repair, or at our option to replace any part of this Meyer Spreader, accessory (other than noted below) except expendable parts such as pins, Spreader fins,and other no
PAGE 6
PARTS & INSTALLATION INSTRUCTIONS MEYER MINI SPREADER MATE © 2010 Printed in the U.S.A. 18513 Euclid Ave. • Cleveland, Ohio 44112-1084 Phone 486-1313 (Area Code 216) email•warranty@meyerproducts.