Instructions / Assembly

(Fig. 1)

(Fig. 2)

(Fig. 4)

(Fig. 5)

STEP 1a

Attach pivot bar to Moldboard using pivot pins coated with chassis

lubricant and 1/8" Cotter Pin. (Figure 1).

STEP 1b

Attach trip springs to pivot bar and moldboard with eye bolts

(Figure 2). Flat end of eye bolt must be in a vertical position to

hinge properly when moldboard trips. Proper tension is attained

when trip spring coils begin to separate and then tighten top

locknut four additional turns. Tighten bottom Finish nut to secure

eye bolt in position. (Figure 3).

STEP 1c

Assemble push frame to pivot bar using 5/8-11 x 3-1/2" Bolt and

5/8-11 locknut. (Figure 4).

STEP 1d

Install auto angling ram to push frame and rod end of auto angling

ram to pivot bar using 3/8 x 2-1/4" Clevis Pin and 1/8" Hair Pin

Cotter (Figure 5). Note: Use two 3/8" Flatwashers to shim up the

rod end of the auto angling ram as shown in parts diagram.

STEP 1e

Assemble Pivot Pin Handle (Figure 6), Spring and 1/8 x 1-1/4"

Cotter Pin (Figure 7), as shown in Figure 8, to pivot bar.

STEP 1:

PLOW ASSEMBLY INSTRUCTIONS

Notch

Cotter Pin

Spring

Pin Assembly Detail

(Fig. 8)

(Fig. 3)

(Fig. 6)

(Fig. 7)

22, 23

7, 11

SAFETY PRECAUTIONS -

See pages 2-3 for de nitions