User guide

58
CHAPTER 3
SIM 3 Configurations and Branches
enter the new text. A faster triple-click (or a slower double click) will highlight the existing
text, and then the new name can be entered.
Figure 3.6. Naming branches in the Branch tab.
NOTE: A branch name may be any combination of letters and numbers
– including spaces and punctuation. Make sure useful names are used to
clearly identify each Branch.
3.1.6. Setting Up Branches in Branch Dialog
The concept behind setting up Branches is simple and straightforward. For any branch
in the system you desire to measure, specify the location of the Console, Processor and
Microphone connection within the SIM 3 system (the analyzer front panel or switcher
connectors). To fully define a branch, you must provide the following information for each of
these measurement points:
■ Name
■ Address (Ad)
■ Channel (Ch)
NOTE: Delay Times (ms) are used to align pairs of measurement points in time
to properly calculate the transfer function between them; this is typically done
using Autoset Delay during measurements of each branch.
Selecting the Name for each branch and channel has already been addressed in the sections
above.