User guide

190
CHAPTER 8
SIM 3 Menus
8.2.4.3. Result
Selecting this item selects the Result graph window view in the Delay Finder and Frequency
Response measurements.
8.2.4.4. Group
Selecting this item selects a two-window view in the Frequency Response measurement,
with the Processor and Room traces in the lower window, and the Result trace in the upper
window.
8.2.4.5. Processor + Room
Selecting this item selects a two-window view in the Delay Finder measurement, with the
Room trace in the lower window, and the Processor trace in the upper window.
8.2.5. Spectrum Max
Selecting this item in the Band or Line Spectrum measurements will show the maximum rms
level measured during a 683 ms time window. This trace will be shown as a yellow line for
each 1/3 of an octave band in Band Spectrum or as yellow dots for each frequency (48 dots
per octave) in Line Spectrum. Spectrum Max may also be enabled using the K hot key.
8.2.6. Spectrum Max Hold
Selecting this item in the Band or Line Spectrum measurements will show the maximum rms
level measured at that band or frequency. This solid trace holds the maximum level of the
signal on the screen, and remains until it is unselected or the measurement is restarted by
clicking Restart on the screen or using the R hot key.
Figure 8.3. Line Spectrum measurement with Max and Max Hold