Operating instructions

CAL OPERATING INSTRUCTIONS
27
2. If they have not already been attached, attach the loud-
speaker brackets to CAL:
■ Place the loudspeaker face down on a soft flat surface.
■ Attach the top loudspeaker bracket (the smaller one) to
the top of the loudspeaker and secure it with the included
hex nut, lock washer, steel flat washer, nylon flat washer,
and spacer. Hand-tighten the hex nut.
■ Attach the bottom loudspeaker bracket (the larger one)
to the bottom of the loudspeaker and secure it with the
included hex nut, lock washer, steel flat washer, nylon flat
washer, and spacer. Hand-tighten the hex nut.
3. Mount CAL on the wall:
■ Insert the bottom of the loudspeaker into the bottom wall
mount plate. The loudspeaker bracket should rest
cleanly in the wall plate.
TIP: An eye nut (not included) can be temporar-
ily attached to CAL’s 1/2”-13 top attachment
bolt (instead of the loudspeaker plate) to lift up the
unit when inserting the bottom of the loudspeaker
into the bottom wall mount plate. The eye nut can
then be removed and replaced with the top loud-
speaker bracket.
■ While resting the bottom of the loudspeaker in the lower
wall mount plate, slowly hinge the top of the loudspeaker
toward the wall until it aligns with the top wall mount
plate.
■ Insert the included quick-release pin into the screw hole
of the top loudspeaker bracket (either side). The quick-
release pin holds the loudspeaker in place.
hex nut
Steel flat
washer
Nylon flat
washer
Lock
washer
Spacer
Hex nut
Steel flat
washer
Nylon flat
washer
Lock
washer
Spacer
1/2”-13
bolt
Quick-
release pin