Product Manual

Installation and Operational Manual
00122-993-01 June 8, 2010
12
INSTALLATION OF SPINNER ASSEMBLIES ON
“S” SERIES SPREADERS
(See pages 14-19.)
SUPPORT SPINNER ASSEMBLY SOLIDLY WHEN
MOUNTING ON SPREADER.
SPINNER ASSEMBLY PROCEDURE:
1. Attach spinner shield to spinner frame with 5/16” x 3/4” bolts and nuts.
2. Attach spinner disc to hub with 5/16” x 1 1/2” bolts, flatwashers and flange nuts.
3. Apply anti-seize compound to spinner motor shaft.
4. Mount spinner disc/hub assembly on spinner motor shaft.
5. Secure disc/hub assembly to motor shaft with proper size hardware (provided). Bolt should
engage threads in motor shaft a minimum of 3/8” when bolt is tight.
6. Attach spinner frame assembly to spinner extension mounting bracket with (4) 3/8” X 1”
bolts and flange nuts.
a. Appropriate spinner height depends on truck frame ground clearance. A shorter
spinner height for light and medium duty trucks with contractor style bodies, a
taller spinner height for heavy duty trucks with full size dump bodies.
7. While holding lock collar in middle notch of spinner extension mounting bracket, slide
spinner hinge rod through both the mounting bracket and lock collar.
(TMS)TROUGH MOUNTED SPINNER OPTION:
1. See pages 16 through 19 for additional instructions.
MOUNTING PROCEDURES:
TRUCK SHOULD BE ON LEVEL SURFACE.
1. Install spinner assembly on spreader by sliding the hinge rod into the mounting tabs on
bottom door. Insert (2) keeper pins into hinge rod. Center and lock spinner assembly
between mounting tabs.
2. Raise and lower dump body to check spinner ground clearances. Adjust
spinner height if needed. Repeat step if adjustments are made.
DANGER