Product Manual

GENERAL INFORMATION

CAUTION: Always disconnect battery before beginning

installation.

Check contents against the parts list to determine all are

correct and included, and also to familiarize yourself with

them.

Locknuts are furnished. DO NOT tighten bolts and nuts

until installation is complete (unless otherwise specified),

then be sure to tighten all attaching parts per specified torque

chart.

When ordering parts, furnish Part No., Name and

Description.

Meyer Products assumes no responsibility for installations not made in accordance with these instructions.

INSTALLATION INSTRUCTIONS

A. Assemble Hitch Assembly (12) to Spreader Frame (3)

using 3/8-16 x 3" Bolt (23), 3/8 Flatwasher (25) and

3/8 Locknut (24).

B. Slide Spreader Assembly into receiver hitch on vehicle

and insert Hinge Pin (22) through corresponding hole

on receiver and Hitch Assembly (12). Secure Hinge

Pin with Linch Pin (26).

C. Tighten all bolts to their required torque using the chart

below.

D. ELECTRICAL INSTALLATION. Refer to Figure 1.

Figure 2