Use and Care Manual

2
Do not discard any contents until after assembly is complete to avoid accidentally
discarding small parts or hardware.
1. Feed wires through the mounting
bracket (A).
2. Securely connect wires as shown
using wire connectors. Connect white
to white, black to black, and connect
the green or copper ground wire to the
mounting plate ground as shown.
3. Secure mounting bracket (A) to the
ceiling mount using long screws (B).
Required Supply Circuit: 120V, 60Hz
1/2 Inch (12.7 mm)
WHITE WHITE
BLACK BLACK
GREEN/COPPER GREEN/COPPER
1/2 Inch (12.7 mm)
1/2 Inch (12.7 mm)
1/2 Inch (12.7 mm)
!
1/2 Inch (12.7 mm)
4. Secure ceiling cover (C) to the mounting
bracket (A) using short screws (D).
6. Install the speciedlightbulb.
5. Lift the Lampshade (E) into place
and secure by screwing on the
Socket Collar (F).
DO NOT EXCEED THE
SPECIFIED WATTAGE.
For use with light bulbs with
a E26 (medium) base.
B
B
D
D
C
E
F
A