User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Fixing
errors
37
Problem
Possible causes
Remedy
The slave flash device or
Studio flash equipment do
not trigger/flash.
The radio-control system
only supports the
camera’s single-shot
function.
Ensure that the camera is
currently in single-shot
mode. The camera cannot
take series of shots in
continuous shooting.
The camera’s flash device
automatically pops up.
The camera is in fully
automatic mode.
Set the camera mode to
P/A/S/M.
The manual settings made
for flash exposure
compensation directly on
the slave flash device do
not take effect.
The manual settings made
for flash exposure
compensation directly on
the slave flash device do
not generally take effect
within the radio-control
system.
Make the manual settings
for flash exposure
compensation directly on
the transceiver.
Synchronisation on the
2nd shutter curtain (rear)
cannot be set up for the
camera or flash device, or
does not take effect.
Synchronisation on the
2nd Shutter curtain (rear)
is not supported for
system-related reasons
Synchronisation should
only be set to the 1st
shutter curtain.
High-speed
synchronisation HSS
cannot be
selected/activated on the
camera.
For system reasons, high-
speed synchronisation
can only be set
up/activated on the
transceiver.
Set up high-speed
synchronisation directly
on the receiver.
The slave device flashes,
but the flash does not
contribute to the
exposure.
The flash device does not
support high-speed
synchronisation HSS.
Deactivate high-speed
synchronisation HSS on
the receiver.
The picture is not fully
illuminated by the
flash/the picture is
partially darkened.
The flash device does not
support high-speed
synchronisation HSS.
Deactivate high-speed
synchronisation HSS on
the receiver.