User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Operating the radio
-control system
32
Performing flash exposure compensation for remote group C
Remote group C effects can be influenced with a manual flash exposure
correction. To perform the manual TTL flash exposure compensation for remote
group C, proceed as follows:
Press button (1) twice.
The EV for remote group C will flash on the display.
To increase the exposure value (EV), press the button next to ‘+’ (2).
To reduce the exposure value (EV), press the button next to ‘-’ (3).
To save the exposure value (EV), press the button next to OK (4).