User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Operating the radio-
control system
31
Setting up flash ratio A:B C
To set up flash ratio A:B C, proceed as follows:
Press button (1) repeatedly until A: B C (8) appears on the screen, as well as
the flash ratio (7) and EV for group C (6) directly below.
To alter the flash ratio, press button (2).
The last value to be set up - 1:6 - will flash (7).
To increase the value for remote group B (i.e. to reduce for remote group A),
press the button next to ‘+’ (3).
To reduce the value for remote group B (i.e. to increase for remote group A),
press the button next to ‘-’ (4).
To save the value, press the button next to OK (5).