User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Operating the radio-
control system
23
Operating the transceiver
Switching the transceiver on and off
To turn on the transceiver, push the master switch to the ON position.
To turn off the transceiver, push the master switch to the OFF position.
Setting up a remote channel
Remote channels (CH) 1 to 15 and Auto (au) are available for the transceiver
in both master and slave mode.
Re
available if the master and slave flash devices are also mounted to a
transceiver, which operates in slave mode as a receiver.
To set up the remote channel, proceed as follows:
Press the channel selection button (1).
On the display page, the symbol (CH) and the last selected remote channel (CH)
(5) will flash.
To select the remote channel, press the button next to ‘+’ (2) or the button
next to ‘-’ (3).
To save the remote channel, press the button next to OK (4).