User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Operating the radio
-control system
22
Assigning a flash device to a remote group
To assign a flash device mounted on the receiver to a remote group, proceed as
follows:
Press the group selection button A (1), B (2) or C (3).
Once a remote group is activated, the corresponding group selection button LED
will illuminate red - A (1), B (2) or C (3).
Ensure the remote group selected is also activated on the transceiver.
Testing slave flash device
To check whether the slave flash device mounted on the receiver can be
triggered, proceed as follows:
Press the test button (1) on the receiver.
The slave flash device mounted onto the receiver will then be triggered.