User's Manual
Table Of Contents
- Information on how to use and the manufacturer
- Security
- Proper use
- Basic safety information
- Avoid material damage and functional faults
- Avoid material damage through use of an incorrect power supply
- Avoid material damage through improper use of batteries
- Avoid material damage due to rain, vapour, heat and air humidity
- Avoid material damage due to moisture
- Avoid material damage through improper carrying
- Avoid material damage through use of one of flash devices built into the camera.
- Avoid material damage through incorrect accessories
- Functional faults due to electromagnetic radiation
- Avoid functional faults due to soiling
- Avoid material damage through improper cleaning
- Design of warning notices
- Design of warnings for material damage
- Description
- Unpack radio-control system and check that all the stated parts are present
- Assemble radio-control system
- Operating the radio-control system
- Operating the receiver
- Operating the transceiver
- Switching the transceiver on and off
- Setting up a remote channel
- Testing the radio-control system
- Setting up remote groups and operating mode
- Setting up synchronisation types
- Manual flash exposure compensation in TTL mode
- Setting up slave flash reflector position on the transceiver
- Setting manual partial light output levels in M-mode
- Setting the flash ratio
- Setting up master and slave mode
- Turning AF beam on and off
- Fixing errors
- Dismantling the radio-control system
- Performing firmware updates
- Caring for and cleaning the radio-control system
- Storing and transporting the radio-control system
- Disposing of the radio-control system
- Warranty conditions
- Contact for service requests
Assemble radio
-control system
18
Assemble the receiver, flash device and stand.
To mount the receiver to the stand provided, proceed as follows:
Turn off the receiver (1) and flash device (4).
Turn the knurled screw (2) against the receiver until it clicks into place.
Push the receiver (1) with the base connector in the direction of the arrow into
the accessory shoe on the stand (1) until it clicks into place.
Turn the knurled nut (2) in the direction of the arrow against the stand (3) until
it clicks into place.
To mount the flash device onto the receiver, proceed as follows:
Turn the flash device’s knurled nut (5) against the flash device.
The safety pin the base connector is now fully inserted into the flash device
housing.
Push the flash device (4) with the base connector in the direction of the arrow
into the receiver’s hot shoe until it clicks into place.
Turn the knurled screw (5) against the receiver until it clicks into place.
The design of the stand provided may differ from the illustration.