User Manual

177
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
Setting the mode of operation
• Switch on the flash unit with the

button.
The start screen appears. Thereafter, the
flash unit always switches on with the
mode of operation that was used last .
• Press the sensor button of the displayed
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
• Press the sensor buttons on the
touch display and select .
• Press the sensor button on the
touch display.
• Set a suitable mode of operation on the
camera, e.g. .
• Tap the shutter release to transfer data bet-
ween the flash unit and the camera.
STROBO
STROBO
M
Setting number of flashes (N)
• Press the sensor button for the number of
flashes on the touch display.
• Press the sensor buttons on the
touch display and select the desired num-
ber of flashes.
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example .
The setting will take effect immediately.
N
4
+
0.6- 7.2 m
F 5,6
M-
Zoom 35
m
m
ETTL
i
EV
MODE
O
q
p
M
STROBO
REMOTE MASTER
3.1m
M-
Zoom 35
m
m
STROBO
i
P
1/8
f(Hz) 5N 5
2,2m
M-
Zoom 35
m
m
STROBO
i
P
1/16
f(Hz) 10N 5
N
O
q
p
3
4
5
+
k