Flashlight Operating Instructions

3.1 Sub-modes of TTL flash mode

Different flash sub-modes can be set when the meca-

blitz is in TTL mode:

The number of possible sub-modes depends on the SCA

adapter and the given camera:

• TTL-remote with address „Ad 1“ (see Chapter Metz

TTL Remote Mode)

• TTL-remote with address „Ad 2“ (see Chapter Metz

TTL Remote Mode)

• E-TTL flash mode (only with SCA 3102 and a suitable

Canon camera; see operating instructions for the SCA

adapter and the camera).

• E-TTL-HSS flash mode; high-speed synchronisation

(only with SCA 3102 and a suitable Canon camera; see

operating instructions for the SCA adapter and the

camera).

• Matrix-controlled fill-in flash (only with SCA 3402

and a suitable Nikon camera; see operating instruc-

tions for the SCA adapter and the camera).

• 3D multi-sensor fill-in flash (only with SCA 3402

and a suitable Nikon camera; see operating instruc-

tions for the SCA adapter and the camera).

• TTL-HSS flash mode; high-speed synchronisation

(only with SCA 3302 and a suitable Minolta

camera; see operating instructions for the SCA adapter

and the camera).

Setting a sub-mode of TTL flash mode:

• Depress the Mode button repeatedly until TTL flashes

on the display. In the event that TTL no longer flashes,

just press the MODE button once.

• Turn the setting disk and select the required sub-

mode.

• Push the setting disk in the direction of the arrow for

storage. The selected sub-mode will be automatically

stored after 5 seconds if the setting disk is not pres-

sed. The TTL icon will stop flashing after storage.

Fig. 4c / Figura 4c / Grabado 4c

Fig. 4a / Figura 4a / Grabado 4a

Fig. 4b / Figura 4b / Grabado 4b

700 47 0078-A4 PDF GB-I-E 30.09.2008 14:12 Uhr Seite 22