User`s guide

Label Requirements
FINISHED LABEL ROLL REQUIREMENTS
Core and Method of Label Attachment
The label stock must not be permanently attached to the cardboard core. The liner must separate
cleanly from the core with 1.0 pound pull tangent to the core as shown in the figure below. No core
material, tape, or adhesive is to remain on the label or liner after separation. Material, especially hot
melt adhesive, remaining on the label will damage the print head.
Die Cutting
Die cutting of the labels must not perforate the release liner.
Slitting
The release liner must be slit cleanly and be made free of edge slivers and dust by vacuuming or
some equally effective process.
UC-ST User’s Guide
5-3