User`s guide

Operation
COOL – COUNTRY OF ORIGIN LABELING
This section describes COOL operation if it is enabled set up properly on your scale. The COOL Text
is normally programmed into the PLU record and this pre-programmed COOL statement will be
called up with the PLU record.
However, if allowed, you can over-ride this setting, as described in the following sections.
When COOL Text is enabled, the PLU Edit screen will show the programmed default text in a small
box at the lower left of the screen. In addition, you may see a “LOT #” key shown next to the GRADE
key that is used for a tracking number.
PLU Edit Screen with COOL Text Enabled
If the COOL Text box has a double line around it (see above), the default COOL text can be over-
ridden on the PLU Edit screen. If COOL Text is Forced, when you call up a PLU record, you will
immediately be shown the COOL Text selection screen as shown below. The second row titled
“LAST” shows the COOL text used with this PLU. If the text is ok, press the box to highlight the text,
or select another text and press the ENTER button to select it.
COOL Text Selection Screen (Standard Mode)
UC-ST User’s Guide
2-15