User`s guide
SmartTouch Master User’s Guide
11-10
Rack Mounting
When installing on a rack or cabinet unit, exercise care to mount the REM securely in
the rack using the recommendations of the rack manufacturer.
Pre-2007 REMs (REM0-5200) are designed for direct mounting in a standard 19” rack
or rack cabinet. Mounting screws are supplied with the REM. Follow the rack
manufacturer’s guidelines to ensure the rack assembly is secure from tipping.
The REM0-5210 is also designed for rack mounting. The extender brackets must be
attached prior to mounting on a standard 19” rack, or rack cabinet.
Attach the brackets with the screws provided by lining up the holes of the short side of
the bracket to the body of the REM. After the brackets have been attached follow the rack
manufacturer’s guidelines to ensure the rack assembly is secure from tipping.
Note: the brackets can be attached to the REM body at either the “front” or “back” of the
unit. Placement is determined by customer preference as to which side of the unit is to
be viewed.
Installation Checklist
WARNING
POWER OUTLETS MUST BE EASILY ACCESSIBLE AND LOCATED NO
FURTHER THAN THE LENGTH OF THE POWER CORD SUPPLIED WITH THE
PRODUCT. FAILURE TO DO SO COULD RESULT IN RESULT IN PERSONNEL
INJURY AND/OR PROPERTY DAMAGE.
•
Rack installation: Install the REM in the rack using the supplied hardware.
After
attaching the extender brackets to the REM unit, refer to the rack manufacturers
guidelines when installing the REM.
•
Bottom mounting installation: Install the REM underneath a UC-ST.
Refer to the
detailed installation guidelines in prior section of the manual.
•
Connect Satellite and STEM Ethernet cables and TNET cable (as necessary).
•
Install Power Cord, Connect to AC Power, Turn power ON.
•
Configure Network Settings
. Use 8461/8361 TNET Satellite, WinDataback for
Windows® or LOADIP2.EXE to set the IP Number.
Note: If the unit has been stored
or transported in below freezing
temperatures, allow the unit to
warm up to room temperature
before turning on AC power.
•
WinDataBack -
The WinDataback for Windows® Program can be used to backup
and restore the PLU file on the REM.