User`s guide

SmartTouch Master User's Guide
Edit Name/Address
Information
To edit the store or current department Name or Address, touch the corresponding line
and make the changes through the alphanumeric keyboard. The names can be up to
12 characters, while the address lines can be up to 32 characters.
Edit Current
Department Bar Code
Number
To edit the UPC number, touch the DEPT UPC line and then enter the Bar Code number
for the current department. This number can be used in place of the Item Number for
some Bar Code formats, and can be up to 10 digits.
Edit Operator Names
Operator Totals allow totals to be recorded for up to 30 operators per department. The
operator numbers can be any 1 to 4-digit number from 1-9999 and do not need to be
sequential. To enter new operator names, touch one of the OPERATOR lines and then
enter the desired operator number (1-9999) through the numeric keyboard. When the
alphanumeric keyboard displays, enter the operator name (up to 20 characters). Note:
The operator slots that are not defined have an Operator Number of 0. Up to 30
operators can be defined per department. (Page through the list to find additional
operator slots.) The operator totals must be enabled in each satellite for accumulation to
take place in the master.
Department Number
To change the Master Editor current department, enter the new department number
through the numeric keyboard or choose from the list. The new current department
number will be displayed at the bottom of the Master Editor Menu screen.
Auto Configuration Rate
This section is used to set the rate of Autoconfiguration. Autoconfiguration is the
transmission of satellite addresses (along with a request for connection command) to
addresses not yet connected to the network. This permits addition of new satellites to the
network without having to manually tell the Master about the new satellite. The
autoconfigure rate is the time (in seconds) between each network autoconfiguration
sequence. To set the auto configure rate, touch CONFIG followed by AUTO CONFIGURE
RATE and enter the desired number of seconds (4-60) through the numeric keyboard.
Setting the rate low may slow network response. The default is 5.
7-4