Reference Manual

Table Of Contents

Draft

Installation and Putting into Operation 17Q3 Dosing Module

1 Using a tube cutter or a sharp knife, cut a sufficient

amount of tubing. The appropriate length mainly

depends on the distance between the bottle and the

pump while dosing.

Recommended length: about 0.7m

2 Connect the air tube (1) to the air inlet of the bottle (2)

3 Insert the other end of the air tube (1) in a tube adapter

(3) and press firmly.

4 Connect the tube adapter (3) to one of the air outlets

(4) of the pump. Press until you hear a click.

When a tube is connected to the air outlet of the pump, the

valve of the air outlet opens. Never leave a tube that is

connected to the air outlet unconnected at the other end

because pressure can not be built up.

You can connect up to 3 bottles to each pump.

Connecting the muffler

− Insert the muffler (1) into the air inlet (2) to absorb the

noise.

Removing the air tube

NOTICE

Damage to tube connectors due to mishandling

If the tubes are not removed correctly, the connectors of the pump and the bottle cap can be

damaged.

− To remove the tubes, press down the ring on the connector and pull out the tube carefully.

1 Remove the tube adapter (1) from the pump by

pushing the connector (2) of the air outlet towards the

pump.

ð The adapter is released and can be removed.