Operating instructions

Special applications and functions
51
During the test, the horizontal segments are displayed.
The balance now prompts you to remove your weight. Lift off the weight.
After removal of the weight the balance processes the results of the test.
tSfc donE
The balance confirms that the test has been performed and then automatically
returns to the weighing mode,
Rbort
BALANCE TEST
03.10.97 15:21:17
METTLER TOLEDO
Type: PG802-S
SNR: 1105238536
SW: 1.74 1.30
Weight ID:
Target:
Actual: 500.00 g
Diff:
External test done
Signature:
END
Notes
You can always abort an ongoing test by pressing the «C» key briefly.
If the test can not be performed properly (e.g. as a result of vibrations), the
balance aborts the operation and "Abort" appears in the display. Press the «C»
key (double beep) to clear this message and restart the test.
If your balance is connected to a printer, the measured weight of the external test
weight is recorded automatically. You can now enter the target weight CTargef)
and the difference CDiff") in the record by hand. The record shown opposite is
a specimen printed out with the METTLER TOLEDO LC-P45 Printer. Depending
on the attached printer, the printout may differ somewhat from the example
shown.