Operating instructions

Special applications and functions
50
Notes
You can always abort an ongoing test by pressing the «C» key briefly.
If the test can not be performed properly (e.g. as a result of vibrations), the
balance aborts the operation and "Abort" appears in the display. Press the «C»
key (double beep) to clear this message and restart the test.
OAT
03.10.97
ANCE
11:34:23
METTLER TOLEDO
Type: PG802-S
SNR: 1105238536
SW: 1.74 1.30
Target:
Actual:
Diff:
Internal
Signature
500
500
0
test
:
END
00
02
02
done
If your balance is connected to a printer, the measured difference is recorded
automatically. The record shown opposite is a specimen printed with the
METTLER TOLEDO LC-P45 Printer. Depending on the attached printer, the
printout may differ somewhat from the example shown.
Test of the balance with external weights
Make sure that the "Test of the balance with external weights" (test E) is
selected in the menu (see Section 4.4).
Ensure that the weighing pan is unloaded and close all doors of the draft shield
(if used). There is no need to tare the balance before the test.
test
\ i
d
\
\ \
Initiate the test procedure by pressing and holding the «Cal» key. The balance
briefly confirms that the test is being performed with an external weight.
The balance prompts you to load the external weight. Place your weight on the
pan.