Operating instructions

Special applications and functions
47
5.7 Adjustment (calibration) with external weights (VariCal)
Depending on the setting selected in the menu (see Section 4.4), the adjustment (calibration) can be performed with the
built-in weight or with external weights. In the factory setting, the balance is setto adjustment with the internal weight, which
you are already familiar with from Section 2.5.
If you wish to adjust your balance with external weights, proceed as follows:*
* The adjustment (calibration) with external weights is not possible with
certified balances.
Make sure that "Adjustment (calibration) with external weights (VariCal)"
is selected in the menu (see Section 4.4).
Ensure that the weighing pan is unloaded and close the doors of the draft shield.
There is no need to tare the balance before the adjustment (calibration).
1/10 d
Cal
long
ii o _ r Q i
LI I 11 I LflL
roi c n n o,
Start the adjustment operation by pressing and holding the «Cal» key. The
balance shows briefly that adjustment is being performed with external weights.
The balance now prompts you to select the desired weight. If you do not press
a key for 3 seconds, the balance automatically initiates the adjustment process.
roi ' n n n ^
LIIL IUUU y
If you do not wish to adjust with the suggested weight, you can select a different
weight by pressing the «!£3» key briefly. The available weights depend on the
balance model.
E>
Co/
Confirm the selected weight with the «E>» key. This initiates the adjustment
process. The balance determines the zero point.
\
Cal
_ mnnnrt— „
IUUUUU y
You are then prompted to load the weight.