Operating instructions

Special applications and functions
37
5.2 Percent weighing
The "Percent weighing" function allows you to weigh in to a preset value (100 %) and determine the deviations from this
target value. The DeltaTrac helps you quickly determine the position of the sample weight regarding the tolerances (see
Section 3.4).
Percent weighing presupposes That you have preselected the function "F100 %" in the menu (see Section 4.6).
Load the empty container.
long
E>
SEt 100 %•
Your balance needs a reference weight that should correspond to 100%. Press
and hold the «F» key until you are prompted to load the reference weight. Now
load the reference weight.
Then briefly press the «E»» key. As long as the horizontal dashes are shown,
your balance is calculating the reference weight.
Note
If you do not press a key for 45 seconds, the balance returns to the weighing
mode.
innnnn
IUU.UUU
On completion of the weighing-in procedure, your balance is ready for percent
weighing.
F
F
te /as6 g
Id 13S6
•. I • •
Weight within tolerance
You can use the «!£5» key at any time to switch the display between percent
display, weighing unit 1 and weighing unit 2.
Note
The current piece weight remains stored until it is redetermined or the power
supply of the balance is interrupted.
The position of the sample weight regarding the tolerances can be quickly
determined with the DeltaTrac. The taring range is ±2.5% of the target weight.
The setting of this tolerance range is fixed and can be changed only via the
interface.