Operating instructions

The menu
30
4.15 Setting display of the icons
on
All icons appear in the display.
flufco off
If desired, you can also switch off the icons. They disappear after about 10
seconds after you have quit the menu or after about 3 min. after the balance has
been switched on.
Note: The menu options 4.16-4.21 are shown only if your balance is equipped
with an RS232C interface.
4.16 Selecting peripheral device
In this menu option you can select the desired peripheral unit. The balance stores the corresponding settings (4.17-4.21)
for each peripheral unit separately.
Pr ,ntE
HoSk
Attachment to a printer (e.g. METTLER TOLEDO LC-P45 Printer).
Factory setting: bd 2400, 7b-E, HS OFF
Attachment to any peripheral unit.
Factory setting: S. oFF, bd 9600, 8b-no, HS Soft
4.17 Selecting data transfer mode
In this menu block you tell the balance how a value should be transferred to a peripheral device (e.g. LC-P45). This menu
option appears only if the setting "HoSt" has been selected in the menu option "Selecting peripheral device" (Section 4.16).
5. off
5. Sfcb
Data transfer mode switched off
The next possible stable value will be transferred after triggering of the Print/
Transfer command.