Operating instructions

The menu
29
floFF 5 '
Automatic shutdown after 5 minutes
As soon as the balance has not been operated for 5 minutes, it switches itself off
automatically.
RoFF ""' '
IU
Automatic shutdown after 10 minutes
As soon as the balance has not been operated for 10 minutes, it switches itself
off automatically.
4.14 Selecting the power-up mode
You can set your balance such that it either immediately starts from the standby mode when you load a weight or it must
be switched on with the «On/Off» key after which it then performs a display test.
The following settings are available:
Quickstart*
This is the factory setting. The balance can be started directly from the standby
mode and is immediately ready for weighing. You can load the weight in the
standby mode and the balance immediately shows the current weighing result.
* Quickstart is not possible with certified balances.
Start with display test
You must switch on the balance with the «0n/0ff» key. After it has been switched
on, it performs a display test in which all display elements light up. On completion
of the test, the balance is ready for weighing.
Note
If the balance has been disconnected from the power supply, it always performs
a display test after it has been switched on again, even if the "Quickstart" setting
has been selected.
F
u
u.
Sfcflr
St Rr
t \
t \