Operating instructions

The menu
23
4.6 Preselecting a function
In this menu option you can preselect a function which you then have available in the weighing mode at a keystroke.
Note: With certified balances, only the functions allowed by the national weights and measures legislation are available.
The following functions are available:
No function preselected
There is no function available in the weighing mode (factory setting).
Piece counting
Your balance counts the pieces which you place in or remove from the weighing
container.
F
F
F
F
F
non'c
PCS
count
Stk
COunt
inn
1U U
ori iu in
\
\
\
\
\
\
%\
A
\
F d'dn
Percent weighing
Your balance allows you to weigh in to a preselected value or it determines
percent weight differences.
Simple formula weighing
The formula weighing function allows you to weigh in up to 255 individual
components, store their weights and totalize these. If your balance is connected
to a printer, all individual weights and the total weight of all components are
printed out. In addition, up to 99 weighing containers can be tared. Your balance
can save and print out the total weight of all weighing containers.
Dynamic weighing with automatic start
Your balance determines an average weighing result over a preset time interval.
This setting is suitable for unstable weighing samples (e.g. animals). With this
setting, the dynamic weighing starts automatically.
B
F d'dn P
r
l
Dynamic weighing with manual start
Analogous to dynamic weighing with automatic start, but the weighing cycle
must be started manually.
You will find details on how to work with the functions in Section 5.