Operating instructions

Weighing made simple

3.3 Performing a simple weighing

For the sake of completeness, the following section describes how a simple weighing is performed.

PG-S 04

o S'OQSc' g

50QS3 g

After you have tared the balance, place the weighing sample on the pan.

Wait until the circular symbol of the stability detector fades. Fading of the symbol

indicates that the weighing result is stable.

Now read off the weight in the display.

3.4 Weighing with the analog display - DeltaTrac

DeltaTrac is a dynamic graphic indicator which shows the weighing range in use

and that still available. You can thus recognize at a glance when the load on the

balance approaches the maximum capacity.

0% in use 15 % in use

55% in use 95% in use

' • i • '

Weight within tolerance

Note

You can use the «!£3» key to switch from the dynamic graphic indicator to a

display with two pointers and two tolerance marks (for percent weighing). This

enables you to determine the position of the weighing result in regard to the target

weight quicker (see Section 5.2). The tolerance range is ±2.5% of the target

weight. The setting of this tolerance range is fixed and can be changed only via

the interface.