Operating instructions

Putting the balance into operation
11
2.4 Power supply
o
n
QFF
Check whether the voltage printed on the AC adapter matches your local line
voltage. If this is not the case, on no account connect the AC adapter to the power
supply, but contact your responsible METTLER TOLEDO dealer.
There are two different AC adapters with national power cable available for your
PG-S balance:
115 V,-20%+15%, 50/60 Hz
230 V, -20% + 15%, 50/60 Hz.
If you wish to work with the holder (1) supplied with the AC adapter: Attach the
holder with two screws to a suitable, sufficiently stable area (e.g. on the wall or
the underside of a bench fop). Press the AC adapter into the holder.
Note
The AC adapter can be removed from the holder by pressing the projecting lug.
Connect the AC adapter to the connection socket of your balance and to the power
supply.
Ensure that the AC adapter can never come into contact with liquids!
The balance now performs a self-test in which all display segments light up
briefly. "OFF" then appears in the display COFF" indicates that the balance has
been disconnected from the power supply).
Press the «0n/0ff» key. The display briefly provides information on the installed
software version and the normal weight display then appears.
Allow your balance to warm up for 30 minutes to enable it to adapt itself fo the
ambient conditions.