Operating instructions

WEIGH IN LIQUID
The balance prompts you to weigh the sinker in the liquid "WEIGH IN
LIQUID".
a) Pour the liquid into the beaker. Make sure that the sinker is
immersed by al least 1 cm in the liquid, and that there are no air
bubbles in the container.
b) Press « » to initiate the measurement.
1.000
*
The balance now shows the determined density of the liquid at the cur
rent temperature (read off on the thermometer).
Note:
●
This result has already been corrected for the air buoyancy. The
buoyancy caused by the immersed wire (Ø 0.2 mm) of the sinker
can be neglected.
●
By pressing «C», the balance returns to "PRESS ENTER TO START".
Result:
Press « », the result will be printed.
Sample printout:
---- Density Liquid -----
18.Mar 2010 20:14
Balance Type ML204
SNR 1234567890
------------------------
ID: ................
Temp. of liquid:
............
Displaced liquid:
10.0023 g
Density: 1.000 g/cm3
===========
Signature
........................
------------------------
16.3 Formulae Used to Calculate Density
The "DENSITY" Application is based on the formulae listed below.
Formulae for determining the density of solids with compensation for air density
= Density of the sample
60 Application "Density"