Operating instructions

12 Application "Totaling"

The "TOTALING" application allows you to weigh in different samples to add their weight val

ues and to totalize them. 1 to 999 samples are possible.

Requirement: The function "TOTAL" must be assigned to the «F» key (see advanced menu

topic "ASSIGN:F").

CLR.M:NO

TOTAL

CLEARED

a) Activate function "TOTAL" by pressing and holding the «F» key.

b) For a new totaling evaluation press « » (or «+» or «–») to enter

"CLR.M:YES" and press « » to clear the memory.

Note: If the memory is already cleared (sample counter is 0) the

memory clear question will be not displayed.

c) Press « » to zero or tare the balance.

- 1 -

999

0.00

Weighing in the sample weight:

a) If using a container: place empty container on the weighing pan

and press «

» to zero or tare the balance.

b) Load the first sample weight.

c) Press « ». The display shows the sample count "- 1 -" and the

current weight is stored.

Note: When the sample counter is displayed you may press «C»

to undo (drop) this sample.

d) Unload the first sample weight. The display shows zero.

Weighing in further sample weights:

The same procedure as for the first sample weight.

●

1...999 samples are possible.

Results:

If the numbers of sample are greater than or equal to 2, press « »,

the results are displayed and printed.

Displayed results:

a) Press « » briefly to show the

totalized value.

b) Press «C» briefly to cancel.

0.5 seconds

number of samples

879

totalized value

TOTAL

8789

49Application "Totaling"