Operating instructions

9 Application "Check Weighing"

The "Check weighing" application allows you to check the deviation of a sample weight

within a tolerance limit to a reference target weight.

Requirement: The function "CHECK" must be assigned to the «F» key (see advanced menu

topic "ASSIGN:F".

CHECK

Activate function "CHECK" by pressing and holding the «F» key.

Step 1: Check Weighing first requires the setting of a reference

weight that should corresponds to the nominal weight, there are 2

possibilities:

Setting the reference in manual mode (enter nominal weight).

Setting the reference in weighing mode (weigh nominal weight).

Step 2: Check weighing needs the upper and lower limits, there are

2 possibilities::

Setting the upper and lower limits in percentage.

Setting the upper and lower limits by weight.

Step 3: Setting tolerance beep

Activate or deactivate tolerance beep.

SET NOM .

Setting possibility:

Setting the reference in manual mode (enter nominal weight)

a) Press « » to activate manual mode.

b) Select the reference target weight by scrolling up («+» key) or

down («–» key). Speed up by press and hold.

c) Press «

» to confirm the nominal weight.

SET NOM .

Setting possibility:

Setting the reference in weighing mode (weigh nominal

weight)

a) Press « » to tare the balance and to activate the weighing

mode. If needed: place empty container on the weighing pan and

tare again.

b) Load the nominal weight.

c) Press « » to confirm the nominal weight.

Switching between manual mode and weighing mode

Press « » to switch between manual mode and weighing mode.

Note: By switching from weighing mode to manual mode the weight

value will be transferred and can be changed manually.

42 Application "Check Weighing"