Operating instructions

8 Application "Percent Weighing"

The "Percent Weighing" application allows you to check a sample weight as percentage to a

reference target weight.

Requirement: The function "PERCENT" must be assigned to the «F» key (see advanced menu

topic "ASSIGN:F".

PERCENT

Activate function percent weighing "PERCENT" by pressing and holding

the «F» key.

Percent Weighing first requires the setting of a reference weight

that should corresponds to 100%, there are 2 possibilities:

Setting the reference in manual mode (enter 100%).

Setting the reference in weighing mode (weigh 100%).

0.0%

175

SET 100%

Setting possibility

Setting the reference by manual mode (enter 100%)

a) Press « » to activate manual mode.

b) Select the reference target weight (100%) by scrolling up («+»

key) or down («–» key). Speed up by press and hold.

c) Press « » to confirm.

I00.0

175

SET 100%

Setting possibility

Setting the reference by weighing mode (weigh 100%)

a) Press « » to tare the balance and to activate the weighing

mode. If needed: place empty container on the weighing pan and

tare again.

b) Load the reference weight (100%).

Note: Reference weight must be at least +/- 10d.

c) Press « » to confirm.

175

Switching between manual mode and weighing mode

Press « » to switch between manual and weighing mode.

Note: By switching from weighing mode to manual mode the weight

value will be transferred and can be changed manually.

Note: If without any key press within 60 seconds, the balance returns to the previous active application.

On completion of the weighing-in procedure, your balance is ready for percent weighing.

40 Application "Percent Weighing"