Operating instructions

"STOPBIT" – Stop Bits RS232C
1)
At this menu topic you can set the stop bits of the transmitted data to different RS232C serial receivers.
"1 BIT" 1 Stop bit (Factory setting)
"2 BITS" 2 Stop bits
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"HD.SHK" – Handshake RS232C
1)
This menu topic allows you to match the data transmission to different RS232C serial receivers.
"XON.XOFF" Software handshake (XON/XOFF) (Factory setting)
"RTS.CTS" Hardware handshake (RTS/CTS)
"OFF" No handshake
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"RS E.O.L." – End of Line RS232C
1)
At this menu topic you can set the "End of Line" character of the transmitted data to different RS232C serial
receivers.
"CR LF" <CR><LF> Carriage Return followed by Line feed (ASCII-Codes
013+010) (Factory setting)
"CR" <CR> Carriage Return (ASCII-Code 013)
"LF" <LF> Line feed (ASCII-Code 010)
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"RS.CHAR" – Char Set RS232C
1)
At this menu topic you can set the "Character Set" of the transmitted data to different RS232C serial receivers.
"IBM.DOS" Char Set IBM/DOS (Factory setting)
"ANSI.WIN" Char Set ANSI/WINDOWS
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"INTERVL." – Print Key Simulation
At this menu topic you can activate a simulation of the «
» key. "INTERVL." simulates a print key press every
x seconds.
Range: 0 to 65535 seconds
0 sec: disables the print key simulation
Factory setting: 0 sec
Note: The executed action is according to the configuration of the print key. (see interface setting)
36 The Menu